MakerGear M2 Dual Extruder

Dr. D-Flo upgrades his MakerGear M2 with dual extrusion. This video features a quick montage of the assembly process. Overall, the upgrade was easy, but wire management seemed like an afterthought in comparison to the single extruder configuration. With only a little calibration, the dual extrusion assembly was printing near flawlessly. 

Resources:

  • Purchase MakerGear's dual extrusion kit - $300 - Here
  • To use the dual extruder you need to upgrade the marlin firmware of the RAMBo found here

Two Colors

 

Specialized Support

 

Conductive Filament